![]() ![]() Clear your browser cache if the web login does not display.ĪFTER FLASHING THE TRAILED BUILD, only use the following builds OR YOU WILL BRICK THE e3000:.Wait 3 minutes and log into web interface.Plug E3000 back in and wait about 5 minutes until it finishes booting.Power cycle by unplugging E3000 for 30 secs.Wait AT LEAST 5 minutes until WLAN (Wireless LAN, not WAN) light turns on.Log into Web Interface and flash the firmware E3000 Initial Flash Trailed Build.Connect 1 Lan cable to pc doing the flash.As a precaution, USB disks should be removed before flashing.Disconnect all cables and wireless clients.Read all required reading sections of the Peacock announcement:.This guide also applies to units converted to an E3000, running Linksys firmware.Be aware that some E-series use nv60k, and others use nv64k. See Where do I download firmware? for links.Īlso reference this post regarding the newer nv60k.bin for Linksys E-series. 17.0dBm All ratesĥGHz output power per TX chain UNII-1 (5150-5250GHz) As factory lists it at a max of 20dBm, then a setting of 100mW could be used as 20dBm = 100mW, 17dBm = 50mW, and so on.Ģ.4GHz output power per TX chain 802.11b: Max. You can use these figures to come up with what Tx power would be best for you. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |